Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Morning All,I now have proxmox VE running nicely on the C240M5 with the VIC1457 card. Many thanks to @Steven Tardy for the direction... The next task is to get the C9800CL WLC running on proxmox. My understanding is that the virtual appliance (can ha...
Was encouraged to cross post over here...Hoping that someone can assist me in figuring out an mystery... I have proxmox 9.2.4 installed on an HX240c-M5 server and am trying to bring up the interfaces on the VIC1457.My initial install did not utilize ...
All,I am looking for some direction on scripting a RestAPI call to our FMC (7.5). I have been able to figure out how to send the API call via curl and find the Auth Token that I then copy/paste into to GET that then returns my info. However, really c...
All,Having intermittent issues where a l2l tunnel will come up and have traffic in only one direction. l2l tunnels are between a 5510 and one of my 5505's. Restarting the 5505 seems to have no effect.The tunnel us set up so that it can be brought up ...
Is there an admin guide for the 5.0.01.0600 VPN software? I am trying to redistrubute the prebuilt config files like I did with 4.6 but the vpnclient.ini and config.pcf files do not get installed.
and success. after redoing all the WLAN configs I now have an operational 9800CL on proxmox that is running on a C240M5 with a VIC1457 nic.Thanks very much @Steven Tardy greatly appreciated...I am wondering if it would be helpful to document the setu...
Hi, vlans 4, 10, and 11 do exist on the 9800CL. currently vlan 4 is in shutdown as it is the production vlan for my wlan that exists on the old 3504 controller. The plan is to mimic the vlan 4 setup on my existing controller using vlan 11 and then to...
Hi Steven, just think that I figured it out. Was going to do another capture this morning but in my fiddling over this I had set the native vlan for the switch port to the vlan that the guest was on. As such, I think that the switch will not add the ...
Hi Steven, and thanks. however no joy yet.I have disabled the physical nic mode and port channel settings on the General Tab for the VICThen in the vNIC tab, have the port set to be a trunk..The switch is set to be a trunk, and I do see the MAC of th...
