Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to add some lightweight APs to my virtual wireless controller. My production controller version is 8.5.151.0. However the APs are on version 8.0.121.As per the cisco document below:https://www.cisco.com/c/en/us/td/docs/wireless/cont...
I have a WS-C3650-48PD that was needing to swapped out due to some ports not working. However when I swap it out with an identical switch (granted its on an older software) DHCP does not work for any of my clients connecting to the switch.The only ma...
The console shows the AP trying to donwload the tar file from the controller. The exclamations go across the screen like it is downloading, then an error pops up and it starts the entire process again.
Yes, on the remote router I have these static routes when I do a show ip route. Note that it's know via .226 the ip address of the switch's interface.S 10.117.7.0/26 [1/0] via 10.117.7.226S 10.117.7.64/26 [1/0] via 10.117.7.226S 10.117.7.128/26 [1/0]...
For testing sake we have not removed the access-group. Since the DHCP is not working for vlan 96 I am not sure if this would fix the issue, but we could give it a try!Attached is the routing config on the remote router. This is how traffic goes back ...
