Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am trying to convert capwap AP to Mobility express.
capwap ap ip 192.168.XXX.X 255.255.xxx.0 192.168.X.X
ap-type mobility-express tftp://tftp-server/AIR-AP3800-K9-ME-8-5-135-0.tar
tftp server is started and could not see any status of copying...
Hi,
I would like to know does 1572i has PoE option or not ?
does it MUST require external power source or is it supported with UPoE switch ?
I read 1570 Series Outdoor Access Point Hardware Installation Guide where in it says 1572i is UPoE supported...
Hi,
I am unable to run Prime 3.0 performance report type Wireless Tx Power and Channel.
if I set the required time period as 1 hour, report runs successfully but if I change the time range it fails to fetch report output.
can anyone help me on this ...
Hi,I would like to know the steps to break the stacked switchI have 2 2960S - 48 port switch which is pre configured for stack... but now i would like to use only one Switch not 2 switches...hence could anyone please let me know the steps to break th...
Hi,I am using 5508 controller and having 2 SSID configuredData - for data users Authentication is [WPA2][Auth(802.1X)] hitting data VLANVoice - for Android and other voice users authentication as [WPA2][Auth(802.1X + CCKM)] hitting Vocie VLANnow my ...
Thanks for your response.
nothing happens on TFTP server ( no progress of transfer data). I use solarwinds tftp server.
no progress on AP console CLI.
its not timing out also, it just says it may take long time after that no update.
Thanks for the response.
so Just wanted to be clear we don't need PoC connection to power up if we have uPoE switch correct ?
and also on the ordering page it shows to select cable modem software even if we don't use cable modem is it something MUST...
