Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I met with a problem with Cisco 7911G ip phone. the symptom is listed as follows,1) when new call comes, there's no response both pick up or hang up the phone receiver.2) when new call comes, there's no response when dial the soft key to answer.3) wh...
Dear all,I met with a problem with Cisco 7911G ip phone. the symptom is listed as follows,1) when new call comes, there's no response both pick up or hang up the phone receiver.2) when new call comes, there's no response when dial the soft key to ans...
hello everyone, I am now facing a big problem. the description is as follows.our company is faced with foreign sites, one in China, and one in France.To reduce the telephone fees, we have established a private line between both sids. so in this case ...
Dear Gajanan, Thank you for your help.But the problem is , 99% of 7911 phones are ok, and only a little phones are not ok. I am trying to find the problem. Because we are using the Chinese version of firmware ( all the interfaces and menus were trans...
the calling protocol is SCCP. but where to find the phoneload/firmware version?I can see the loaded file is "SCCP11.8-4-4S", "tnp11.3-0-1-32.bin"the CCM server is "Cisco Unified CallManager 4.3 Administration"
dear marwanshawi,thank you for your answer. but can you recommend me some links to see how to set the translation patterns for incoming calls ? thank you!my UCM version is 4.5.
I think there would be some changes in Call Manager server, to fake the incomming call with prefix 0033 (from France) to a Chinese local call number. I don't know if my suppose is right and if it's right, how to set the CUCM server?
