Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Community!We have a situation where we need to disable SQLNET Inspection in the FMC Cisco Firepower 2110 Threat Defense.I would appreciate your guidance on how to do this using the GUI and the command line.I found the information about...
Hello Community!We have two ASA5508s with failover (one active and one standby).We need to reboot both firewalls due to a memory leak issueWhat is the reboot process?1. Check the status of the failover2. Reboot the backup firewall.3. Check the status...
Hello Community!Need expert advice on troubleshooting the ikev2 VPN tunnel. The tunnel is in "UP" state and the remote and local selectors are also in UP state. The role of the tunnel is "RESPONDER" on our side. As far as I understand, this means tha...
Hello Community!We received the alert that the switch 1 in the stack had a "Removed" status.Switch# Role Mac Address Priority Version State-------------------------------------------------------------------------------------1 Member 0000.0000.0000 0 ...
Hello Everyone! We have the VPN installed with a remote client, but I have not seen a local/remote selector for some IP range in the VPN tunnel. The ACL is already set and an interesting IP subnet has been added to it.I have a question, how will the ...
