Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi friends,I have four sites which are now connected by MPLS connection.Each site is connected to the provider on a /30 mask ip address,One IP address on the CE side and on the PE side.An OSPF in configured on the Cisco 2811 router connecting to the ...
I am using an 4 Mpbs ADSL connection on a Cisco 877 router for just internet access only.I want to consolidate the internet access from my central location.Is there any way to aggregate multiple ADSL connection or load balance with any of the cisco r...
We are planning to implement MPLS connectivity between our 3 offices and data center. Data center will have a access port of bandwidth 34 Mbps and other 2 offices with 10 Mbps and one office with 2 Mbps bandwidth.From each office the MPLS is connecte...
HiI have 4 nos 2Mbps aggreagated link on two 2811 router.I have configured a multilink ppp for aggregation.How can i setup QOS for voice calls on the link.The protocol used is H.323 .How to identify the voice traffic on router.Can NBAR be used to ide...
Hi,we have 4 nos 2Mbps Leased Circuit.I have 2 Cisco 2811 with 4 Serial Interface on both sides.How to aggregate 4 nos 2Mpbs leased line on serial interface on cisco 2811 router
Are you using a 2960S with full POE (740 W) or 370 W ?.If you are using a 370W PoE switch,it might be drawing more power..i had the same kind of issue with Avaya Phones...it was more to do with the PoE not with the configuration..
Hi,I tried redistributing static and default subnet what you said before also but then it didnt work since i put redistribution of static and default route on all routers which made a loop.Now today i put it correctly on the routers which the static ...
Hi Giuseppe,The links will be from the same ISP.i need one ethernet connection going to my firewall.Can i do this on a cisco 2800 series router with couple of ADSL cards ?.What i am plannig to order is 3 ADSL connection if this is possible or is ther...
i will have 2811 router on each site connecting to PE.my each 2811 site router will be a ABR with separate area connecting to a backbone area 0 on PE.am i getting it rt ?Can you please detail this ?.
