Hello,I need to design a small network that has some limitations such as Only one port to Router. But I need to connect the 2 IE switches as shown below. Is there any way in switch configuration can be used to achieve this.
Hello,PLC = Programmable logic Controller (Typical OT Control System).Regarding the Red line connectivity. To extend the uplink connection from Switch 1 to Switch 2. If that answer your question.
Hello thanks, both, I did a bit of checking, and in a simplified way, the architecture may look like this. I will try to check if the suggestion works with this or not. Is it possible to check this on Packet Tracer?
