Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 300+ 887VAG and VAMG routers out in the field running DSL and 3G.They all work fine on Day 1, but after a while (we don't know how long) the cellular interface goes into the following state.A shut/no shut of the controller or the interfaces d...
Is it possible to change the Ethertype used on a ME3400 switch (12.2(55)SE).Our carrier uses 0x8100, but when we configure a QinQ port and send double-tagged packets to them, I think they are going out ax 0x88a8.I've found commands to do it on a 10K...
I setup a connection between two Ethernet Subinterfaces, each on a seperate vlan.At the other end of the trunk (on a switch), the port goes into BKN (broken) mode as bpdu's from VLANa are now appearing on VLANb (because of the connect statement on th...
Can I setup a Pseudowire between to subinterfaces on the same router (7206).We take multiple VLAN's from a carrier over a trunk connection. I want to be able to pseudowire between two of these sub-ifs (and then apply some form of vlan translation??) ...
Hi AllI have a pair of Cisco ME3400G-12CS switches running resilient WAN ethernet circuits.I believe the CAB-SFP-50CM= SFP patch cable will allow me to stack them, but it's only 50cm long.My two devices are in two different data centres, joined with ...
Hi ScottIt's been a while since you posted this.. We have exactly the same scenario.. Did you ever get an answer?We reckon that the "ghetto looping" idea will work, and although it feels wrong in every way, there's no technical reason why it won't wo...
