Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an existing infrastructure where the AP management subnet (192.168.4.0/22) is the same as the WMI (192.168.4.2) on a 9800-40-K9. So the radius source address on WLC towards ISE is 192.168.4.2. Currently i have an existing infra with 10 APs but...
is there any best practice regarding which interface to use for radius authentication requests. its either the management Gi0 or an SVI. i believe that you can route the SVI out of a port-channel on the 10G interfaces then there is more redundancy wi...
I have a requirement for a script to use the following API/dna/intent/api/v1/wireless/accesspoint-configuration/summaryis there documentation to state what specific user role is required for this? i have granted API write access under the Platform ro...
I am running the dna/intent/api/v1/network-device/config API which is getting the config for all devices at once. what is the meaning of ID in the response for the API? I assumed it is the same ID in dna/intent/api/v1/network-device 'Get Device List'...
There is a limit of 5 commands when running commands on Command Runner via the GUI. is it possible to bypass this limit? I have tried running the python script fromCommand Runner - Cisco DNA Center Platform - Document - Cisco DeveloperThis works fine...
thank you for the recommendation, i have used the wireless config analyzer. super useful. i notice it did not pick up the wmi / ap management subnet separation (i.e. wmi should be a different subnet to the ap mgmt subnet, is there any reason for that...
