Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a 9124AXI connected with a POE injector. (the PoE injector is a Cisco mGig 60W .3bt injector)I log in to the EWC and go the Access Point and under power status I see "Power Injector/Full" - so far I assume full power and everything is onlin...
Sorry for the delayed reply.The switch was a C2960-24P but it is now a C9200-24PXG-E but the "issue" still remains.I think it's just showing the PoE "pulling" the 15.4WI guess there is now way to check how much W the 9124AXI is getting?Thank you,
Good Morning,You should have another option further down as Georg Pauwen mentioned and it looks like the below: (image below)Not all NICs have this option though so you may not always see this option. @getaway51 wrote:The objective would be PC or lap...
