Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a WLC4402 and ACs 4.1I am trying to implement EAP-TLS. But the clients are not associating with the APs. The log shows that the Association has failed due to unspecified reasoncode 1.When i implement PEAP in the same setup i am facing no pr...
Hi,I have a IPS 5.0 which is being managed through VMS 2.2 with IPS MC 2.1. When i try to push configuration from VMS to IPS i get the follwing error.The UI sensor version 5.0(1)S149.0 does not match the real sensor version 5.0(1)S206.0 no deployment...
Hi Guys,I need some information!Is the IDSM2 hot-swappable in a Cisco 6509 Chassis?Recently I installed the IDSM2 on an Cisco 6509 Chassis (with two Sup720s in SSO mode). But chassis rebooted specifying that the "%C6K_PLATFORM-2-PEER_RESET: RP is bei...
Hi..I am facing the same problem... i.e. IP Phones are discovered as "End Hosts" in user tracking.And yes i am discovering My CCM as an Application server and not as call manager.I am running LMS2.5.1 with Campus manager Version 4.0.5Would you think ...
Well u can define a static route with a metric of "0". (try, it is possible).But you would face one problem.This solution will only work if the static route you have given is more specific than the directly connected network.Check and let me know!
Well, I understand the power of and remove procedure in IDSM2 blade.I faced this specific problem when i was "INSERTING" the card the chassis.So again my question arises.What do you think?is there specific requirement when i have two SUPs?
