Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 C9407R in stackwise virtual. Then there is multiple power outage on both, then the startup-config disappeared each time I apply power back.I was applying the backup config each time to restore the network.But now:1. remote/ssh stopped workin...
Hello all,Is it possible to have a route that failover to another ISP2/Connection in the aftertoon from the main ISP1 which is regular. So, I have 2 Towers in same location, both having different ISP. Tower2 is residential and often less busy in the ...
Hi all,I am migration from an older nexus switch to Nexus 9k. Now I have that CoPP configuration not working on N9k. Kindly see below:ip access-list copp-system-acl-ping10 permit icmp any any echo20 permit icmp any any echo-replyclass-map type contro...
HelloI write erase a nexus 9k switch. After reload where it askhey guys.... I want to upgrade one nexus 9k... so during fresh boot, when presented with this:2023 Oct 4 18:57:09 switch %$ VDC-1 %$ %POAP-2-POAP_INFO: [FLM270403DE-6C:29:D2:19:02:9B] - S...
to fix this issue:1. Go ahead and set the enable password 2. The you get 3 options [0] , [1] and [2]3. Select [0] option (this will not save the password you set in step 2 above)4. You are logged in with no enable password(see images attached).
