Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,Our company is embarking on a new project to install firewalls across hundreds of RTU Scada System sites. Currently, our infrastructure is predominantly Cisco, including switches and routers. There is a debate within our team: one group suppor...
Hello ,Please can someone confirme for me if cisco IE3300-8T2S-E switches support DLR protocol .we have lots of allen Bradley plc which are connected to stratix switches ,our supplier they want to replace the stratix switches by the IE3300-8t2s-E a...
Hello,i have two ie5000 switch located in the same cabinet,these two switches are connected through sfp fiber .these two switches are getting very hot and the sfp port transceiver temperature that connect these two switches reach 88.6 c.then one of t...
Hello Bandi,I have another question ,i am using putty to configure switches and router so when i throw all the configuration at once the switch get stuck ,so i have to devide the proccess of copy and paste in the terminal ,part after part untill i re...
Hello sir,i really appreciate your help, so we received a new switch ie5000 same model as the previous one .i am going to replace it and i am going to replace the single mode fiber cable and sfp connectors with the multimode cable and connectors, so ...
Hello ,i already tried factory resetting this switch through express setup ,notyhing happen ,always there was sys blinking light, i even held the express button for 5 minutes .any other recomendation?
Hello balaji,they ordered long fiber cables.waiting for them to arrive and then we will see if it will work.anyway i am next to the switch now ,i pulled all cables from it ,i am trying to reset it ,nothing is showing in the console ,no light only "s...
