Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've recently upgraded from 4.2 to 5.0, and started getting these alarmsAP's Interface:0(802.11b) Operation State Up: Base Radio MAC:00:1d:46:fd:f4:b0 Cause=Admin ConfiguredI've seen some issues with some clients deauthenticating, does this means the...
I have 2 controllers 2106 both with the same mobility group, I have 3 APs in one controller and 3 APs on the other. I have just one rogue detector. Do I need a rogue detector on both or just in one controller?
When it prompts for the current password is actually the BIOS password.http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_password_recovery09186a00801ece5f.shtml#biosRegards,MR
Reboot the box and verify the IP setting again, because it will keep loosing the IP. This is already documentedhttp://www.cisco.com/en/US/customer/ts/fn/New/fn63058.htmlRegards,Mauricio.
Rob, thanks for your response. I have the following doubtThe Antenna AIR-ANT2480V-N connects directly to the 1520, this means the antenna has a male N connector and the AP hasa N female connector. Likewise, the antenna AIR-ANT5180V-N (N-MALE) connect...
