Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneI am in the process of implementing cat 9800-40 and AP 9136i-E in my infrastructure. Currently I have already managed to run HA sso between two WLCs and connect two APs along with configuring wifi network. I noticed that the APs that conne...
Hi everyoneI enabled in my infrastructure WLC 9800-40 in HA mode (sso). Now i preparing configuration for AP, i will use only one model AP (Catalyst 9136I) so i added new IP scope (for AP) in infoblox with option 43 where i added hex value witch IP p...
Hello All,I want to run a WLC HA in my infrastructure consisting of two cisco WLC 9800-40. I do not have any purchase documentation and do not know if I need to buy any additional license for the number of APs connected to this WLC in order to connec...
Hi everyoneI started use Cisco CML 2.6.1 and i have problem with VERY SLOW boot network devices in LAB. One router IOSv boot 20 minutes, when i create lab witch 2xRouters (IOSv) and 2x Switches(IOSvL2) i cant enabled all devices. To VmWare player 17 ...
Hello, everyoneI use Cisco ISE 2.7 in my infrastructure. I would like to ask you whether it is possible to add the mac addresses of devices to MAB Groups and to add a time parameter after which such a MAC should be automatically deleted.For example:I...
Thank you for your reply :-). It's VM with CML install on my laptop , I turn off my antivirus (eset node32) and increase RAM for CML Vm to 32GB RAM. Still same problem all devices added to LAB turn on very very slow
Damien thanks for your reply,The problem occurs on the following switch:WS-C2960S-48FPS-L 15.2(2)E9 C2960S-UNIVERSALK9-MThe phone registers correctly in the network, the connection between the telephones is established correctly, the telephones downl...
Thank you very much for your reply.As you wrote the Cisco ISE system after the device is authenticated on the network overwrites the ACL the connected device then gets a dACL below :permit ip any host y.y.y.y # CCM_IP_1permit ip any host x.x.x.x # CC...
