Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 4507 and just implemented Zabbix to monitor our infrastructure (replacing Nagios). I am now starting to see a lot more information about potential issues than I did with Nagios which is a double-edged sword.The biggest issue I'm seein...
This morning I received an alert that my backup server (standalone UCS C240 M4 running windows) had run out of disc space on C and had shut down. The C drive is a mirrored set of 120Gb SSD discs and the storage array is a number of 1TB sata drives i...
I cleared the counters about 5 minutes before the output I posted. The duplex setting on the switch side is Full, but I do not have access into the Verizon device to check that, same goes for the speed. I am not seeing these errors on other ports.L...
Hi,All drives have been re-seated with no change. I removed power (disconnected power cables) for more than 2 minutes, with no change.I do not see any HDD/SSD in the disk slots under CIMC Sensors.So all signs are pointing to this being a hardware is...
Reverting the firmware had no change. There are ZERO hard disks detected by the unit at all. Choosing "upgrade HDD" detects no devices to upgrade. This is extremely frustrating and has put our organization in a very bad situation.
Hi, thanks for responding.I did upgrade the RAID controller and the disk firmware when the other components were upgraded.I have not yet tried to revert the firmware upgrade to v2.0(?). Where would that be available?There are currently NO physical di...