Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Can you please let me know if I can configure BGP on a Cisco 3550 switch (WS-C3550-48). It is currently running Version 12.2(44)SE1.If not, what would be the recommended version in that device?Appreciate your response.CheersNavneet
<p>Hi ,</p><p>I have a site with around 100 users. There are total 3 Vlans for each of the floors. Users on one floor are not able to access the PCs of other users (on different floors) using the hostnames. But they can do this with IP address.</p><...
Hi All, I have configured a tunnel between 2 sites. I had originally configured Diffie Hellman Group 1 on the ISAKMP policy on remote and Hub end.I have changed the DH group to 2 now. I can see that the Tunnels and Eigrp are up still, and traffic is ...
Hi, I had IP multicast rate-limit configured on my E1 link in a 7206 router. The Card used was PA-MC-8TE1+.I have moved the link over to a Cisco 6506 device, and terminated the link on a SPA-8XCHT1/E1 module on the SIP 200 controller. The IOS version...
Hi ,Can anyone please let me know how to check loops between points A and Z? When I need to check the local loop at point A or Z, where should i ask the service provider to give the loop from? Iam pretty confused the way this troubleshooting with loo...
Hi Collin, Thanks for your reply. Can you please let me know where we can find the list of protocols which are supported for a particular IOS release?CheersNavneet
Thanks for your reply!!We dnt have much of a configuration from the user end. There are policies defined in the DHCP scope, and IP helpers on the Data VLan for users to get IPs.Does the name resolution process try and contact the DNS servers which ar...
Hi rick, Thanks for your reply!! I checked on the crypto ACLs and could see that the traffic count was increasing. Also, on the IPSEC SA, i could see the packets getting encrypted. So I guess, iam safe with the configs.Thanks for your answer CheersN...
