HiI have to propose a Wi-Fi zone for a university.There are around 8 floors and I plan to go with 1200 seriesA simple solution which would come to your mind is 1231g (IOS) installed in WDS mode.Documents shows thatClient1==AP1==WDS==AP2==client2will ...
HiI have to propose a network which is in compliance with SAS 70 Audit.The network is very simple. Internet Link will terminate on my ASA 5505 and from there the wires will go into my 1200 APs.The network consists only of Laptops.I will be using 802....
HiI am trying to connect a WS-5483 (1000BaseT GBIC ) in 4507R switch to a PIX 515e (10/100) port.To my amusement, the link is cot comming up.I have tried both straight and cross cables. IF I am connecting the same WS-5483 with other WS-5483 in anothe...
HiI have a 2950 switch which was not configured,i.e its working in transparent mode.Now I am trying to configure it, but cant get through the console.I have changed the computer as well as the console cable.Can anyone help me?
Hi(1)Are you able to get the following?Router#config terminalRouter(config)#(2)does the following command (which will change the "enable" password to "cisco" work?Router#config tRouter#(config)#enable secret ciscoIf you are able to do the above menti...
HiThe image you have supplied is specific to 1721.1720 does not run "advanced security" images.You can check that yourself by www.cisco.com/go/fnRegardsJD
HiIf its factory configured and you are able to view the config then its already into configuration mode.Which prompt do u see ?"Router>"or"Router#"If its the first one, then forget recovering if your console is damaged.If it the later one, then you ...