Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello-I am wondering if I could get some feedback on a utility that can be used to monitor collisions (source of problem) on the switches in my cluster. Current setup: 8 x 3548's -> 1 x 3550 in a star config. There seems to be alot of latency at tim...
Hello, Is there anyway to gather info on power outages, or internal failures from the switch cli? If no, how can I monitor this kind of activity? Any help is greatly appreciated thx.
hello-I currently have an active project on migrating one of my IDF's to another subnet, due to the need for more address space. I just came in to this position and I need some guidance. Can you direct me to what information I need to collect in orde...
hello-I currently have an active project on migrating one of my IDF's to another subnet, due to the need for more address space. I just came in to this position and I need some guidance. Can you direct me to what information I need to collect in orde...
Mcconnell- here is a screenshot from MRTG on the suspect switch @ a 5min average. Also ports 40-48 keep blinking amber..could this be overload or just failing hardware?
I followed the link to the mib's @ somix, and selected the appropriate file. Can i copy the code straight out of the file and past it into the *.cfg file for mrtg? Or do I have to make more changes? Sry if this is a noobish question.
Mcconnel - I ran the show int cmd and the ports on the suspect switch are reading Auto-Duplex (FULL). Should these be set explicitly to Full, to run virtually error free as you described?
Thank you for replying...this was helpful, but I was looking more for a way to capture a power failure into a log file somehow...is this at all possible...thx in advance.
