Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Goto Devie > Phone, find your phone and open the device configuration. Then click on the line configuration. Near the bottom of the screen of device configuration you will find LINE # on Device SEPMACADDRESS. In there you have two settings, RING Sett...
Vince, did Meraki ever get back to you with a solution to this in a firmware fix. We are no experiencing similar behaviour with our IP Telephones, Cisco 8851's. We are using MS250's with 11.22 firmware. I am considering disabling the LLDP on the phon...
I recently had an issue with Proximity due to firewall setting. The Videounits were on one VLAN, and the end users using wifi on another VLAN. OurMeraki MX Security device was not always allowing traffic to pass betweenthe two vlans, so the security ...
Instead of making a silent ring tone why not set the ring setting under the Directory Number configuration of the device to flash only. This would achieve the same thing and be much simpler.
