Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone seen this issue with the 1852i APs? We have 3 APs that flap all day everyday. The LED cycles red, amber, green continuously and never joins the WLC. The cables tested out fine and we attempted a factory reset on the APs.Jan 27 12:06:10: %L...
Has anyone seen all remote pairs showing as "Pair A" and Not Supported? Below are the results from the switch. For reference this is on a Catalyst 3850 with an Aironet 1852i access point on the distant end. This AP has been going down every few days ...
We have seen a very high failure rate for the AIR-AP1832i-B-K9 recently with no known cause. Some displayed a solid amber led and others displayed no led. After swapping out the AP with a spare, the spare comes online right away. Some just go down an...
I am unable to connect a console to the AP as I am no longer onsite and will not be again for a month or two. I expect the AP to join via CAPWAP.Option 82Same Layer 2 domain
Yes it is going through a total of 2 patch panels as are several other APs on the same switch, none have the above result. What makes this more odd is you would think it'd be a cabling issue, but the AP is currently up and showing this. I'm stumped.I...
Thank you for the response.I don't think power is the issue especially since when we put a different AP on there it comes up perfectly fine. The power drawn at 15.4 W is pretty standard from my experience it is typically that or 17.9 W. The vast majo...
