Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Operating in underground mines, we often face problems with the cables to the access points.We have about 3000 access points in operation.What’s the best way to check if a cable is cut so an AP loses connection to the WLC?We mainly use the NETCONF in...
We are operating our vehicles remotely in the underground mines over Wi-Fi, the data load from the machine is constant around 30Mbit/s (yes, six to eight HD-cameras).When switching between APs we have noticed that we sometimes get a transmission gap ...
We are pushing traffic using a packet generator on a client at a rate of 10Mbit/s via a Cisco AP C9120AXI-E.Using the following command we can fetch the BSSID counters form the WLC9800.show wireless stats ap name AP8C1E.8025.7D7C dot11 5ghz slot 1 wl...
We have this Cisco 9124AX for the European market, configured as WGB (work group bridge) and we would like to use it on non-DFS channels on the 5GHz band.However, we are not allowed to add any such channels to the scan list, we can only use channels ...
After a couple of weeks with extensive testing with hundreds of AP roaming events at high uplink load (30Mbit/s), we found that the problem is gone after upgrading to WLC version 17.15.1.
Yes, we have to use 17.13, we have many many AP model 9124, and we need 17.13 to be able to run then in indoor-mode enabling non-DFS channel usage (we can not use DFS channels in our setup, it causes too long communucation gaps so the machines will m...
Thanks Marce, yes, we have gone through the usual troubleshooting processes, what makes it tricky is that it's so tight correlated to the traffic load. We have tested adding a UDP packet generator (then skipping the cameras, so only the safety mechan...
