Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,We are trying to have the call forward feature working using 7940 SIP phones and call manager 5.1.The problem is that if we try to call a phone that was set to forward all its incoming calls to another number, via the "CFwdALL" button, we ge...
Hi,We have a call manager 4.1.3 with sccp ip phones.We have also a SIP gateway (AudioCodes Media 2000) that connects our lab to the PSTN.We created a SIP trunk between the CCM and the SIP Gateway, but we didn't manage to have people from the PSTN cal...
My Access Point is running the ios: 12.3(8)JEA and the boat loader version is: 12.2(8)JA.I need to configure the Access Point with Proxy Mobile IP. In conf t mode, the ip ? command does not show any proxy-mobile command.In the http setup page, the se...
Hi,I have 5 Catalysts (3550, 3750, ...) sharing 4 vlans by using trunking ports. If I do a transfer (FTP, ...) which has to pass through one trunk, then the bandwidth is very low (< 300 kbit/s). Is this "bandwidth reduction" normal?If not, could I ex...
Also, according to the traces, this is what happens :Phone A tries to call Phone B which is configured via the softkey "CFwdAll" to forward all its incoming calls to Phone C.- Phone A sends a SIP invite to CCM5- CCM sends this SIP invite to Phone B- ...
I would like to configure the AP to run proxy Mobile IP. The AP will behave as a MIP client for the wireless Node. The Configuring notes of Proxy MIP indicates that proxy MIP should be installed on the AP. ThanksStephane
Hi,The port assignments are:Cat3550, port 0/13: FTP ServerCat3550, port 0/24: Trunk VLAN200Cat2960, port 0/22: trunk VLAN200Cat2960, port 0/12: FTP ClientI remarked that when I do the FTP transfer, the port where the FTP Client is connected to is bli...
