Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I also don't see errors on debug L2 and debug L3Cisco 3900 ISR w/PVDM3 DSP DIMM with 128 Channels T1 0/0/0 is up.Applique type is Channelized T1Cablelength is long 0dbDescription: ATT CircuitID 101/T1ZFN/STLSMO11DC1/STLYMOOAW00No alarms detected.ala...
The correct exam answer (actually I need to know the wording used on the exam) is that there isn't a default. Both protocols are listening. To go a little further on this, SSH might error out if not configured properly (PC may also need config). Thi...
My question is similar..... The company I am at now uses SIP/SIP on a 4331, CUBE is not enabled nor is there a license. As I was learning about SIP-to-SIP I was under the impression you needed CUBE to operate in this configuration, so I'm a bit con...
