Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm upgrading a PIX from 6.3(5) to 7.0 with Ezvpn. The config moves over fine, however, none of my remote VPN clients can connect. I'm receiving the error: "Removing peer from peer table failed, no match! Error: Unable to remove PeerTblEntry"I had ...
Hello,I'm trying to setup client VPN on an 1800 that already has a GRE VPN tunnel. Apparently, the router tells me that I cannot have an EazyVPN server as well as GRE on the same interface. Does anyone know a workaround to this? I'm simply just tr...
I'm curious how I can authenticate my 1300 bridges as a client to a WLSE Express.. The WLSE Express does have a built in AAA server and i've created the usernames, but, i'm not sure where in the 1300 I can assign it to authenticate to the WLSE.. My q...
Thanks for your response.. I do not have access to the configuration file right now, but, yes, the crypto map is created for the tunnel interface, and then bound to the outside interface.. When I try to create the EZVPN server (GUI), it pops up and ...
Not sure if this has been answered or not, but, you do need to assign an access-list to the outside interface. You can do it a couple ways (icmp outside permit any any) or, create an access-list and bind it to the outside interface. You do need to ...
