Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We are migrating from Nexus N3K-C31108PC-V to Nexus 93180YC-FX3 switches and want to swap the SFPs in the N3K switches to the new N9K switches, however some of these SFPs are SFP-10G-LRM optics and the SFP compatibility matrix doesn't list these ...
Hi,I have been trying to migrate IW3702-2E-UXK9 access points configured as Mesh APs (bridge mode) on a WISM2 to a Cisco 9800 WLC HA-Pair with no success. I have successfully migrated 2702/3702 access points configured as local mode.I have copied the...
Hi,
I have a client with access points registered with a Catalyst 3650 IOS-XE wireless controller and would like to re-register these access points with a new CT-5520 wireless controller running Aire-OS. Is there a procedure for doing this?
Thanks,
...
Hi,I submitted this question on the Network Management forum yesterday & was advised that CDP must be enabled to allow Campus Manager to discover trunk links correctly. I was advised to submit on this forum as to whether anything further can be done ...
Hi,We have a customer with Cat6500 VSS chassis configured with Etherchannel 802.1Q-in-Q links between Edge & Distribution switches. The distribution end of the link is configured as an IEEE802.1Q tunnel port whilst the Edge end of the link is an IEEE...
Hi,
The issue I had was that the AireOS to IOS-XE config conversion tool missed the 2 commands listed, though it had included other AAA commands. When I added the additional 2 commands to what had already been configured under AAA I was able to succe...
Update. Procedure that worked for me is;configure on C9800 aaa authentication dot1x default localaaa authorization cred default localset primary WLC as C9800 and secondary as AireOS on MAP high availabilty settingset primary WLC as C9800 on RAP high ...
Hi,I added the commands suggested aaa authentication dot1x default localaaa authorization cred default localI then moved the RAP from the AireOS WLC to the Cisco 9800 WLC and it successfully joined but the MAPs that were associated with this RAP beca...
Thanks for the response. The document you list is the one of a few config guides I've followed. Strangely, I get the same errors the document shows in the troubleshooting section but that section doesn't explain how it was fixed!The conversion tool d...
