Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I do understand what is access-list and why should i use it but i'm not sure about ip access-group on the interface to WAN.In my case i have access-list on 1841 router along with relevant ip access-group on the wan interface. If i need to add add...
Hi,I have two cisco routers with tunnels between them.The keep alive is 3 2 on both of them.what should i do in order to have line protocol upThank you for your help
Hi,How can I monitor any out going connection to internet on interface Ethernet using port 443.I have router 1841.Please helpI did the following ruleaccess-list 106 permit tcp any eq 443 any established logthen on the proper interface ip access-group...
HiI have only guest access into cisco web site.How can I download the image for 2600 router is it possible without having support on the router itself.Thank you in advanced
Hi,I'm trying to recover forgotten password on the 2600 router. I have been doing exactly as it written in the document however no luck.this what i do reboot into rommon > confreg 0X2142resetno on the promtenablecopy startup-config running configshow...
Hi Rick,Thank you very much for your prompt response.You said that this should write the message into syslog but how can make sure the event records under sh log command as well.The thing is that i don't have reliable syslog server yet Thanks again
Hiwhen I did tftpdnld -u eventually resolved the boot problem.The problem then become that the config is not saved either, which I resolved with config-reg parametrsThanks
