Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,At our school, our district office is on a point to point wireless connection that at the moment is un-reliable and dropping packets due to interference (we think). All of the traffic from this office crosses this wireless link (internet, VOIP...
Hello,I work for a school district and we connect an off campus building via 2 - Alvarion B100 5.4 or 5.8 Ghz radios. Sorry I'm waiting for an answer from our vendor re: which they are. We run VOIP and Data over this connection. The VOIP quality st...
Hello,I'm trying to ghostcast across subnets. The ghostserver is connected to a 4506 Cat Switch. Most clients are connected to 3560, 3550, and 2950 switches. I know that at one building multicasting won't work becuase multicasting has to be turned...
Hi,Am working on implementing QoS in a building in our district. Which switches need this command: ?mls qos trust dscp? and what switch needs ?Auto Qos? enabled?Here is the breakdown of this buildings network:1 - Cat 3750 - core switch w/ IP rout...
Hi. Please forgive my lack of knowledge regarding QoS, but I must ask for help. I am supposed to get QoS configured on 11 switches at an elementary school in our district. An engineer has been hired to set it up at the other buildings as they were...
I hear what you are saying. Actually, the 2801 and the 3506 are both in the Remote building location. At current time all phones and machines plug into the PoE 3506. The floating static route is something I had thought of as I touched on this in a...
Giuseppe,thanks for the reply! Just to clarify, we have the 2801 and the Catalyst 3560 both in one closet in this building. At this point in time, I'm not sure what device would make up the other end of the tunnel in our network. Right now we have...
Thanks so much for the info! I'll check into it. It has been tricky in the past for them to ghost. I just started here and in the past they have used directed broadcast. But that isn't good for large labs. We would much rather prefer using multic...
I have "auto qos voip trus" configured on one of the 3560 switch's uplink ports. Do you think I need the massive config of auto qos --mls qos map....mls qos srr-queue input bandwidth....all of those commands generated from auto qos. Do I need those...
