Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am installing a new NMD-36-ESW in a 3745. I can't find much documentation on how to configure this module. All I want to do is make all the Ethernet ports part of the same LAN segment. When I look at the config it looks like 36 different etherne...
I have a 3640 with an NM-16AM (analog modem module). I'm trying to get the dial-in users to authenticate with the Windows Domain Controller via a TACACS+ server (SecureACS 3.2). When the user tries to connect, they get "Error 734: The PPP link cont...
I have 2 offices connected via a T1, currently used for data only. Each end has a Cisco 2621 with a WIC-1T for the T1 termination. Ethernet is connected to a LAN on each end. Each office also has a Mitel PBX. I would like to combine voice and dat...
Which screen is this selection on? I looked at CiscoSecure ACS --> Interface Configuration --> TACACS+ Services menu and have the following selected for both user and group: PPP IP, PPP LCP, SLIP. "PPP Multilink" is not selected. I also have "Adv...
Since my original post a few months ago I've made some changes to the configuration & now have it up and running. I have the relevant portions posted below for the benefit of other readers.The TDM group under each controller carries the voice data f...
Thanks for the response. The solution looks workable.If I don't need the dynamic bandwidth allocation between voice and data, will the VWIC-2MFT-T1-DI support both voice and data on the T1 without using the NM-HDV-2T1-24=? A sample config would be:...
