Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Tandberg 2500 that will not keep all of the H323 settings after a restart. Everytime we restart the system we have to change the call setup from direct to gatekeeper and then set the E.164 alias to get it to register. All of the other sett...
We have a newly provisioned P2P DS3 circuit between HQ in Virginia and a remote site in Colorado. Users in Colorado are reporting slow performance. Verizon has allegdedly tested the circuit end to end and says they see the full T3 bandwidth error f...
I am having an issue with my remote sites using 1811 routers. With the "Detect noncompliant HTTP traffic" option checked under application security, they are unable to go to yahoo.com and I see the Sig:15 Protocol violation when they attempt. Any s...
Well I found out that it is s 3000 and not a 2500 and there was startup.prm file overrighting the settings. The startup file has always been there and they used to only do direct dialing, but they added a MOVI system and needed to register with the...
Thanks for the response Joseph>We are not seeing interface or controller errors on either side of the circuit so I am still mystified at the throughput disparity. I would assume based on the results of trying to TFTP the IOS from the Colorado router...
OK this is the default configuration, and it is only associated with FE0 outbound which is the ISP connection. It will allow me to associate it with inbound but will not let me deselect outbound. I changed it using the CLI. Odd though that the SDM s...
Yes, I have it disabled at the moment and there is not a problem getting to yahoo with it disabled. I am wondering why it would do this though. Thanks for the reply.
