Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA 5510 appliance we've had for a while now. Previously I had it connected to our switch from the int Eth0/1 to the switch lan port. No Vlans, no layer 3 routing, just unmanaged switching. Now I have 2 vlans configured on my switch (it'...
We have a Cisco ASA 5510 security device. Here recently it seems every day at the same time (between 3 and 4 pm) our internet connection (4 bonded t1's) comes to a crawl. I've looked through the Cisco but haven't been able to find anything useful. ...
I just setup a new Cisco ASA 5510 with the help of the wonderful support staff at Cisco. My setup is as basic as they come: on a t1 going to my firewall then my layer 2 switches to my lan. I need to allow traffic for my exchange server, RRAS serve...
I've been tasked to replace our old sonicwall tz170 firewall with an ASA 5510 and configure it (which I've never done, only routers and switches) and I have a few questions. I'm inside the ASDM and I'm trying to setup my outside interface... The 55...
Thank you for the response. The way the config on the firewall is now, there is no tagging on Eth0/1 (default vlan)
interface Ethernet0/1
description Inside LAN interface
nameif inside
security-level 100
ip address 192.168.200.1 255.255.255.0 ...
I got it fixed! I had the nat for it going (inside,inside) instead of (inside,outside). I do have another quick question about the SSM card though. Does the port have to be on the network for it to work? I know to manage it I have to connect t...
Ok I got the firewall up and running, internet traffic works great. Problem is I'm having an issue with my NATs Ithink. I setup access rules for my servers inside my network. For example I have an access list that allows any outside traffic coming...
I'll be having fun this weekend! I just configured my pat and my route to my gateway. I'm working on therest now. Thank you so much! If I have issues I'll post my config.
