Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a translation-rule that is not working just the way i need. I need to take number dialed IE 95555555 and translate to 7725555555. the rule i have now translates 95555555 to 97725555555 and i need to strip the 9 before its sent to the pr...
I have a Cisco SPA500S connected to a SPA525G the line buttons light up green but do not change when extention is in use. Is there a blocked port or some other issue?
I have two cisco 1200 that i need to pass traffic from one building to another. I have two 3524 poe switches one on each side. i want to trunk or pass 2 vlans over the radio but i need to set up like a trunk as if i was just trunking the two switches...
CAN ANYONE TELL ME WHAT THES DEBUG ERROR MESSAGES MEAN. ALSO HERE IS MY IAD CONFIG AS WELL. NEED HELP PLEASE!Jul 13 15:55:51.848: ISDN Se0/0:23 Q931: RX <- BAD PACKET()Jul 13 15:55:51.848: ISDN Se0/0:23 Q931: do_statistics: protocol 0x80 protocol not...
hi billi still have a problem with calling some area codes because of the local service provider. most need a 1 but some like 954, 305 and 561 need to be dialed 10 digit. how can i change this plan to accomodate that?thanks in advance
SO I WOIULD NEED TO REMOVE THE DUP PEER 9 AND ADD ONE WITHdestination-pattern 9[2-9]...... FOR LOCAL. SO IF I DO WITH TRANSLATIONS WHAT WOULD THE TWO TRANSLATION PATTERNS LOOK LIKE?
Hi Bill,Im sorry i wasnt more specific. What I need to make this work is a rule that transforms 91xxxxxxxxxx to 1xxxxxxxxxxfor long distance and 9xxxxxxx to 772xxxxxxx. basically the carrier needs a 1 and the area code for LD and just the area code f...
helloocalim still having an issue. i used the above rule and it fixied my issue but caused another. here is what i need. my provider requires 1 and the area code for long distance and just the area code for local calls. we are dialing a 9 but need to...
