Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just implemented a straightforward NAT using overload working, however, I have a question about the limits I see on the show ip nat pool command. For example:ASR-CO-F8#show ip nat pool name ComcastLR-WLNAT Pool StatisticsPool name ComcastLR-WL, id 9...
I have a pair of 6509 switches, both running 12.2(33).Switch 1: 6509-I#dir /all%Error opening disk0:/ (No such device) Switch 2:6509-II#dir /allDirectory of sup-bootdisk:/ 1 -rw- 54337444 Mar 2 2009 16:54:26 -05:00 s72033-ipbase-mz.122-33....
Configuring FWSM in a 6509. When I set "firewall vlan-group 40 40-42,251", it results in: "No more than one svi is allowed. Command rejected.". I had "firewall multiple-vlan-interfaces" set for a previous use of this module, but took that off with...
I have a 6509 with many VLANs and a seperate DHCP server to provide addresses. I need to create an additional VLAN (VLAN 20) and I would like to use the 6509 as the DHCP Server for the new VLAN. I know to set up:ip dhcp excluded-address 20.20.20.1 2...
Attempting to set up the FWSM in transparent mode (single context). Here is my scenario: I have a 6509 with 3 VLANs…40 (DMZ), 41 (Staff), and 42 (Inside). I would like to use the FWSM to control access transparently between the 3 VLANs. Here is wh...
gp1200x,We moved from 1G to 10Gb and like you, our stats are not reflecting reality. Can you share the combination of MRTG parms that you used with cfgmaker? Thanks
Thanks, I did that and "dir all-filesystems" worked. Interesting that the /all works on one but not the other. In both cases there is nothing in disk0:
I "think" I followed the instructions ... placing two VLANs in a single bridge_group (although that goes against everything I believe about routing!) ... but still can not seem to control access between VLAN 40 & 41. I still have full access between...
