About mikjsmith

mikjsmith · 04-21-2012

Hi I have a Linksys PAP2T-NA which was setup and worked fine using the sipgate service. This week I was in mid-call and the line went dead. I rebooted the adaptor at which point I lost the dial tone on the phone plugged in to the adaptor. I have the...

mikjsmith · 04-27-2012

Thank you for replyig so quickly!! So, two points:1. There is no dial tone and the PAP clearly receives the digits from the phone but doesnt dial out2. The PAP clearly receives a request from the ISP ("Tryging To" and "Ringing To") when I dial in but...

mikjsmith · 04-27-2012

2012-04-27 14:36:12 user.notice 10.0.0.12 \n2012-04-27 14:36:12 user.notice 10.0.0.12 OP:STUNTS = 16 ( 16 68)\n2012-04-27 14:36:12 user.notice 10.0.0.12 OP:SUBDLG = 2 ( 2 6436) 2012-04-27 14:36:12 user.notice 10.0.0.12 OP:SIPLIN = 0 ( 2 1...

mikjsmith · 04-27-2012

2012-04-27 13:32:00 user.notice 10.0.0.12 \n2012-04-27 13:32:23 user.notice 10.0.0.12 [1]On Hook\n2012-04-27 13:32:21 user.notice 10.0.0.12 [1]Off Hook\n2012-04-27 13:32:11 user.notice 10.0.0.12 fu:0:8231, 0003 0001\n2012-04-27 13:32:11 user.notice 1...

mikjsmith · 04-26-2012

I *can't* make a call from the PAP. There is no dial tone and I cant make or receive calls. I *can* access the PAP configuration through the telephone however (****)Ive attached the regional parameters. Hope this helps. Very frustrating....could be a...

mikjsmith · 04-26-2012

I've now put a 2-wire cable in and still get the same problem.Any more thoughts at all? It seems unlikely to be defective given that it did work and that the unit logs in to the SIP service, as well as allowing acces through the phone to the adaptor ...

Member Since	‎04-21-2012 04:43 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	9

User Statistics

User Activity

PAP2T-NA no dial tone

PAP2T-NA no dial tone

PAP2T-NA no dial tone

PAP2T-NA no dial tone

PAP2T-NA no dial tone

PAP2T-NA no dial tone