Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Morning,I have a remote site that still utilizes a single T1 connection to me. For multiple reasons we had to scrap the old T1 and have a new one put in. The old T1 resided on a T3 as channel 25. The new T1 is a standlone point to point. I r...
Good Morning,I don't use VMware but am responsible for the network infrastructure it runs on in our data center.I don't know specifically what version of ESX they are running but on my end the Cisco gear is stacked 3750Gs.One of the techs from the VM...
Good Morning,We suddenly started having problems multicasting from our Internet2 connection last month, In the past two weeks we have had two conference calls with Cisco TAC totaling 9 hours. We have them stumped so far.The problem we have is we ca...
Good Evening,This morning when I went to multicast an I2 stream I discovered somehow my multicast is broken to my perimeter router. I can receive SAP announcements, IGMP memberships establish and PIM joins look good. By all accounts it should work....
Good Evening. I hope someone can help me because I am at my wits end and TAC is at a loss. It seems that shortly after I applied the IPS-K9-6.2-1-E3.pkgIPS 6.2 Minor Upgrade File (All Supported Platforms Except AIM-IPS and NME-IPS) to my 4240 last ...
What do you mean by "Floodset to stop forwarding"?
I am not familiar with the term "floodset" but I believe I am experiencing the same issue and will try upgrading from 3.9.1 to something else.
Thanks,
Joe
I appreciate the response from everyone.I built a simple hardware loopback using CIsco's documentation and the serial interface comes up fine when looped. I am going to contact the carrier in the AM.Regards,Joe
I had the same problem recently on a 3750.I had PIM running across two load balanced equal cost interfaces to a remote site where the 3750 is.I turned off PIM on one of the interfaces on the 3750 and the issue went away and hasn't returned.Regards,Jo...
Giuseppe,Yes I know TTL is expressed in router hops but I am just trying to figure out what else I can relate to the 255 seconds of it working. Maybe somehow the the TTL is increasing once a second... I don't know. My mutlicast threshold is set to ...
