Hi All, We have a 6513 with dual MSFC/Sup720 (12.2(17r)S2) and have ordered a WS-X6724-SFP blade (w DFC3B daughter card). The node runs CatOS.Were hoping to run voice across one of the links into this card and have run into a possible issue - can any...
Hi, Ive just tried putting TACACs onto a 7206 VXR (124-4.XD4) and am getting the following error:%AAA-3-BADSERVERTYPEERROR: Cannot process accounting server type tacacs+ (UNKNOWN)Config is vanilla and has been used on other switches/routers in the ne...
Hi, Were a small ISP and just looking for a few ideas regarding an issue weve come up against. We offer two basic services ? all based on Ethernet backhaul:1. Layer 2 VPN only ? Customer given VLAN between 2 sites. Eg Csr ?VLAN 100 over SP net - Csr ...
Hi All, Just looking for some ideas to troubleshoot a Mgt Vlan issue. We have quite a large, flat L2 network running RSTP and have been having issues with the VLAN for some time. Basically its flakey with some switches (and devices behind them) dropp...
Hi, We're an ISP and currently have one provider giving us a full table as transit and also peer with a few local exchange points. We're looking at getting another transit provider in who are also going to give us a full table (they have better Asian...
Hi, Ive tried this with an 1841 and its restricted with regards to LDP/VPNv4 functionality. As per above post, the 3800 series is the most cost effective solution for MPLS in the core. 3825 is base while the 3845 offers better PPS (500k vs 350k)and o...
Guys, Thanks for the continued input. Debugs attached and I also added the tacacs source interface command. From the debugs it appears that the TACACs server is not responding. The server logs didnt come up with anything although its still reachable ...
Hi Rohit, Thanks for the feedback. Ive removed the command and the issue still appears to be that the router doesnt recognise TACACs although it accepts the commands. When the config is applied it bypasses TACACs for authentication and goes to the en...
Hi, Yes, totally agree. Think MPLS/VRFs are the way to go. New hardware but the best option over a single VLAN to get the routing table seperation. Thanks for the feedback.
