Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am having problems with a SIP trunk which is terminated by my ISP. I can make outbound call fine but inbound calls are just engaged. I know the IP is being send from the ISP because I can see packets through the firewall and if i unplug the call...
Hi all,I have just moved from CCME to CCM. In CCME to make calls from outlook all I did was install the tapi driver and enter the username, password and the address of the CCME box.I have installed the new tsp driver for call manager and entered all ...
I have what should be a simple requirement. I have a call manager 5.1 server and I want to set up an authenticated trunk (username and password) to my isp who will then terminate all my calls.However this is causing me no end of issues. Can any one g...
Sorry, this may not be much help but I had the same issues. After many long phone calls to Cisco it appears that BT don't use the same hardware at each exchange and some of these exchanges play merry hell with this router. I dropped in an 837 and nev...
OK this may be a silly question, Im only asking coz i had a similar issue with AOL a few years ago.Are you sending BT the correct CLI? Or are you hiding your CLI? I believe 192 is a subscriber service and if BT can't see who to bill then they may re...
