Hello All, I want to implement Flexible netflow in our network where all cisco devices will be exporter and Cisco Prime Infrastructure 3.3 as a collector.Assurance license is installed. But as per the cisco document :https://www.cisco.com/c/en/us/td/...
Hi There , After added Hp switch to prime 3.9 , i faced SSH issue for access and tried to manual-SSH acording prime cli to SSh hp Switch and it woking fine.the issue with GUI when try to make ssh to sw
SOLVED In the first, you need to configure the end device, but be careful, the port will be 9991Then prime detected auto that device running NetFlow and prime will working as collector for itThen you will going to Dashboard / Overview / service assu...
I did this because I faced the same issue, so I did it. If you saw the comments in the last post that were solved by someone sharing a video and the video not working, Thanks for your support.
thanks , for your fast response . i have cisco prime infrastructure 3.9 Virtual , and i have been added cisco Devices and it working normally with it . and when added none cisco device "Hp - Switch " i get this message"Check whether the Telnet/SSH, T...
