Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently purchased a cisco AIR-AP1252AG-A-K9 stand alone wireless access point to serve guest users at a reference area. In trying to get this working, I've used the "debug dot1x all" and "debug eap all" commands, but can't seem to see any info. f...
I'm running a Cisco PIX and need to determine if an INSIDE IP is connecting to and OUTSIDE IP and when it occurs. I thought I could make an access-list entry with a permit and then log it. Anyone done this before?
I am struggling with the same problem. We currently have a PIX for the firewall and a Cisco 3005 VPN concentrator for IPSec. With that scenario, the connection works as described in the diagram (substitue the VPN for the ASA). The tunneled default ...
The problem was found. I needed to have "authentication key-management wpa version 1" under the "ssid bibliotheca". The following config. connnects my guest users vi wpa ver 1, TKIP and a username and password that is authenticated on my ACS server...
If you use two (or more) 3750s for aggregating access switches (3550, 3560, ...)they will allow physical redundancy over an etherchannel link that has one link (or more)connected to different physical 3750s. This is because two switches stacked toge...
Thanks for the response. I set it up to log at level 1 so as to avoid a bunch of other stuff from cluttering up the output. If I go for the packet specific info, I'll use the "capture" command or put a sniffer on the segment. Thanks again for the ...
