Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi GuysI was just a little confused about this.While optimizing / manipulating EIGRP using the K Values what are the units in which we specify each of the metricsE.gmetric = [K1*bandwidth + (K2*bandwidth)/(256 - load) + K3*delay] * [K5/(reliability +...
Have a look at the link below http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtmlMake sure the size of the IOS version you are trying to use will fit into memory.HTHPlease rate posts that helpRegardsArvind
You might have to approach the testing center co ordinator with the printout of the statement that states you have passed the exam. He / she will initiate necessary proceedings from the centers end thereafterHTHArvind
Hi there,AFAIK the pause output counter refers to the number of PAUSE frames recieved by a port. That being the case, I found this explanation for the counter that you describeThe number of PAUSE frames recieved by this port. The PAUSE frame must hav...
I know it might sound very difficult but could you capture a show interface on an affected port when the workstation loses connectivity?Also, now that there are no errors (hopefully) I think you may have successfuly proved that the existing cabling i...
Talking about switching, all broadcast "frames" would have a source mac address (specific to the NIC / device) and a destination of all 1's. You may have to locate which port the mac address is being learned from and follow the switched network path ...