About arvindchari

arvindchari · 03-08-2006

Hi GuysI was just a little confused about this.While optimizing / manipulating EIGRP using the K Values what are the units in which we specify each of the metricsE.gmetric = [K1*bandwidth + (K2*bandwidth)/(256 - load) + K3*delay] * [K5/(reliability +...

arvindchari · 03-09-2006

Have a look at the link below http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtmlMake sure the size of the IOS version you are trying to use will fit into memory.HTHPlease rate posts that helpRegardsArvind

arvindchari · 03-08-2006

You might have to approach the testing center co ordinator with the printout of the statement that states you have passed the exam. He / she will initiate necessary proceedings from the centers end thereafterHTHArvind

arvindchari · 03-08-2006

Hi there,AFAIK the pause output counter refers to the number of PAUSE frames recieved by a port. That being the case, I found this explanation for the counter that you describeThe number of PAUSE frames recieved by this port. The PAUSE frame must hav...

arvindchari · 03-08-2006

I know it might sound very difficult but could you capture a show interface on an affected port when the workstation loses connectivity?Also, now that there are no errors (hopefully) I think you may have successfuly proved that the existing cabling i...

arvindchari · 03-08-2006

Talking about switching, all broadcast "frames" would have a source mac address (specific to the NIC / device) and a destination of all 1's. You may have to locate which port the mac address is being learned from and follow the switched network path ...

Member Since	‎12-26-2005 10:48 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	157
Total Helpful Votes Received	166

User Statistics

User Activity

Quick EIGRP K Value metric question

Re: How Ereas Flash Of AS5300 in Rom Monitor mode

Re: Exam history

Re: Pause Outputs on Interfaces

Re: Cisco 2948G-GE-TX lost packet

Re: Many bcast and mcast packets