Since you are using console port; the fastest would be to copy your current config and paste in a text file format and then on your new router you can download it using the tftp command or you can just paste the config directly to the new router/Than...

Hi Masood,If you are using a windows machine; the TFTP command will do the job and same goes for the cisco IOS.You really dont need a specific TFTP client to upload or download TFTP files.Thanks

Hello,Dynamic Trunking Protocol (DTP) sends the VTP domain name in a DTP packet. Therefore, if you have two ends of a link that belong to different VTP domains, the trunk does not come up if you use DTP. In this special case, you must configure the t...

Also it is a good idea to built the visio diagram as you get necessary information using CDP NEIGHBOR command on each device; so you have a topology map for future use.Once you build your topology work on your Management IP address range and assign e...

CE 500 SWITCH Command was: sh vtp status---------- VTP Version : 2 Configuration Revision : 0 Maximum VLANs supported locally : 36 Number of existing VLANs : 11 VTP Operating Mod : Client VTP Domain Name : VTP Pruning Mode : Disabled VTP V2 Mode : Di...