Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had the exact same issue at home for ages.Having gone around through everything I eventually discovered that if you turn OFF the IP inspect for ESMTP then it works fine.I've had this happen more than once on multiple firewalls and routers and this ...
Normally I've used type 5 E&M (type 1a on merridian ) for integration with routers. I did have serious problems getting a Micon Marathon to work - and had to used type 1 or type 2 i think.Also, make sure you have DTMF relay on all your dialpeers. If...
Dan,Maybe I'm being a bit slow about this - but when I run the cfgfmt.exe tool I get a warning about an invalid entry for the upgradelogo key.I've just taken the sccpexample.txt and added that one line to it.I copied the gkdefault.cfg to the director...
Hi Phil....There are two similar ways depending on your hardware......The cheap and easy way is to use the aux port on your router. connect the devices to the aux port on each side, and once you set the basic flow controll stuff etc, use the 'autoco...
Gatekeepers assume that all calls are 64kbps regardless of the codecs used.When you place a call through the gatekeeper, it deducts 64k from the amount of bandwidth available until the call is finished. So, if you want to use 4 g729 calls over the w...
