Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to be able to permission certain groups where they can have full rights and all commands on their local devices and restricted commands on outside devices. In the Assign a Shell Command Auth on a per NDG basis, can I throw in their NDG in and ...
I currently have one ASA 5510 sitting behind one of my edge routers and I'd like to also use this same device to firewall another WAN link. Currently the 2 networks behind each WAN link can talk to each other through our core router. Is this doable? ...
one of our ASAs is having problems authenticating against our tacacs server. We can run the test authentication feature fine and the ASA can ping the server. However when I try to authenticate I see this in the log:4 Aug 28 2007 09:30:31 409023 At...
Has anyone experienced any issues making calls (over IP) with Polycom VSX7000's behind pix/asa firewalls? Despite permitting open IP access between the two units, one unit will call and it will ring continiuously with the other side not receiving it....
I'm thinking about firewalling off 2 WAN links from 2 ISPs with just one ASA. I'm going to setup second and third interfaces facing the WAN and treat them as if they were individual and just add routing to forward traffic as needed. I know of a setup...
That will be placed on the interface of the switch connected to the ASA. Basically what's going to happen is that you configure that switch port to trunk (to allow multiple VLAN traffic through) and then on the physical port on the ASA, you then crea...
You can have multiple VLANs from one physical interface by creating "sub-interfaces". The only catch is the interface at the other end (on your switch for example) would have to be configured as a trunk port to allow multiple VLANs.
I took a look at those logs. I see the hits when I run the test authentication from the ASA (I'm logged in locally as fallback at the moment) but when I try to login as normal with my AD creds I dont see any hits.
