Buy or Renew
Buy or Renew
serenesetup
Level 1
Level 1
Member since ‎01-08-2006
‎08-18-2017
Recent Badges

User Statistics

  • 16 Posts
  • 0 Solutions
  • 12 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
See all
First Discussion
5 Discussion Posts
10 Discussion Posts
1 Reply
10 Replies
5 Replies

User Activity

RAPID STP configuration

01-22-2006
RSTP will be configured on ten 2950 switches connected to two 6500 core switches. Only CLI command I found about RSTP is:switch(config)#spanning-tree mode rapid-pvstis that all i need? no need to configure edge ports?and is RSTP a sub-second process?...

TCP delay on catalyst switch

01-20-2006
i experienced a TCP delay on catalyst 4506, avoid the problem when i replaced 4506's with dummy unmanaged switches.i used two PCs(PC 1 and PC 2) and two 4506 switches (S1 and S2)PC 1 is connected to S1 (fast ethernet port)PC 2 is connected to S2 (fas...

loop-free topology with unmanaged switches

01-17-2006
please see the attached figure.there is a loop on the network. and unfortunately unmanagable access switches do not support stp/rstp. i am trying to establish a loop-free architecture with what I have.Altought it looks a dumb idea, what if I configur...

how to supply server redundancy that supports (r)stp?

01-17-2006
in a huge network; access switches, distribution switches and core switches are all redundant. but I like to make redundant connection for my server too. (server has 2 ethernet ports) which software should I install on the server? I suppose the softw...

how to make response time of switch faster?

01-17-2006
on 3750, when1. execute ping -t command from a PC to the switch interface vlan 1 ip address, 2. unplug the cable and plug it again, it takes about 30 seconds to start pinging again.i disabled the STP protocol and observed that; with the same procedur...
Community Statistics
Member Since ‎01-08-2006 12:12 PM
Date Last Visited ‎08-18-2017 03:54 AM
Posts 16
Helpful Votes Given To