About 1qaz2wsx1qaz

1qaz2wsx1qaz · 03-15-2006

Hi All,I am using pix 7.0 and vpn client 4.8When I connect with the vpn client I can see the subnet behind the pix (10.61.1.0)However there is a router on this subnet that connects to two other sites (10.61.2.0 and 10.72.2.0)I can ping from the pix c...

1qaz2wsx1qaz · 02-14-2006

Hi All,I can get vpn to work if I use internal IP address's, however if I change the IP pool to a different subnet I am unable to connect from an external client to the internal network.The client shows no secure routes listed under the client statis...

1qaz2wsx1qaz · 01-26-2006

Hi All,I am trying to setup an IP Pool on a different subnet than my local LAN. If I setup a vpn pool using my internal LAN addresses everything works fine.When I use an IP Pool other than my local LAN, I can connect to the PIX and the VPN client PC ...

1qaz2wsx1qaz · 01-22-2006

Hi All,I can set up a vpn connection using an ip pool of valid internal ip address's (ie internal network 10.10.10.0 ip pool 10.10.10.30~50). Everything works fine, access to other pc's on this subnet etc.However if i try to set using an ip pool of 1...

1qaz2wsx1qaz · 01-09-2006

Hi,I have a PIX 515E running vers 7.Is it possible to use VPN with only 1 static IP address from the ISP (no gateway or ISP router ip address is suppled).I can set up routing on the ADSL modem but then the PIX does not have a valid Internet IP addres...

1qaz2wsx1qaz · 03-20-2006

Hi Jacko,Thanks for the help, everything is working fine.Regardsty

1qaz2wsx1qaz · 03-16-2006

Thanks for the tips aashish,Still not working, I thought to make it easier to troubleshoot I would only work on one other subnet.I have configured the VPN pool to use ip's from the 10.61.1.0 subnet so as eliminate any routing problems from the router...

1qaz2wsx1qaz · 02-15-2006

Thanks for the suggestion.The port is open.When I use an internal IP address pool, everything works fine. I am using the 4.8 vpn client and when I use the different subnet ip pool I am unable to get a secure route (see earlier mail)I still can connec...

1qaz2wsx1qaz · 02-14-2006

Hi Raj,"Allow local LAN access" was not enabled. But the problem still exists, there is no secure route displayed on the client statistics screen?The client stats show packets being sent but none recieved?On the pix if I run sh ipsec sa I get:#pkts e...

1qaz2wsx1qaz · 01-23-2006

Hi Patrick,Here is the current config.PIX Version 7.0(1) names!interface Ethernet0 nameif Outside security-level 0 ip address 192.168.10.253 255.255.255.0 !interface Ethernet1 nameif inside security-level 100 ip address 10.10.10.253 255.255.255.0 !in...

Member Since	‎01-09-2006 02:30 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	12

User Statistics

User Activity

VPN client can't access different internal subnet

PIX 515 ver 7 vpn config help

PIX VPN Setup - IP POOL

VPN connection using different subnet?

Pix 515E v7 VPN config help

Re: VPN client can't access different internal subnet

Re: VPN client can't access different internal subnet

Re: PIX 515 ver 7 vpn config help

Re: PIX 515 ver 7 vpn config help

Re: VPN connection using different subnet?