Hi All,
I am trying to setup an IP Pool on a different subnet than my local LAN. If I setup a vpn pool using my internal LAN addresses everything works fine.
When I use an IP Pool other than my local LAN, I can connect to the PIX and the VPN client PC can receive the settings from the PIX firewall, however I am unable to see the local LAN.
Below is the config, am I missing a route or an access-list?
All help gratefully appreciated.
PIX Version 7.0(1)
names
!
interface Ethernet0
nameif Outside
security-level 0
ip address 192.168.10.253 255.255.255.0
!
interface Ethernet1
nameif inside
security-level 100
ip address 10.10.10.253 255.255.255.0
!
interface Ethernet2
nameif DMZ
security-level 50
ip address 131.131.131.253 255.255.255.0
!
enable password xxxx
passwd xxxx
hostname pixfirewall
domain-name wtm
ftp mode passive
clock timezone EST 10
access-list Outside_access_in extended permit icmp any any
access-list inside_nat0_outbound extended permit ip any 10.10.10.224 255.255.255.240
access-list Outside_cryptomap_dyn_20 extended permit ip any 10.10.10.224 255.255.255.240
pager lines 24
logging asdm informational
mtu inside 1500
mtu DMZ 1500
mtu Outside 1500
ip local pool Dial-In 10.10.11.1-10.10.11.239 mask 255.255.255.0
monitor-interface inside
monitor-interface DMZ
monitor-interface Outside
asdm image flash:/asdm-501.bin
asdm location 10.10.10.224 255.255.255.240 inside
no asdm history enable
arp timeout 14400
global (Outside) 10 interface
nat (inside) 0 access-list inside_nat0_outbound
nat (inside) 10 0.0.0.0 0.0.0.0
access-group Outside_access_in in interface Outside
route Outside 0.0.0.0 0.0.0.0 192.168.10.254 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00
timeout mgcp-pat 0:05:00 sip 0:30:00 sip_media 0:02:00
timeout uauth 0:05:00 absolute
group-policy try internal
group-policy try attributes
dns-server value 10.10.10.16 10.10.10.2
username xxx password xxx encrypted privilege 0
username xxxx attributes
vpn-group-policy try
http server enable
http 10.10.10.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp
crypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmac
crypto dynamic-map Outside_dyn_map 20 match address Outside_cryptomap_dyn_20
crypto dynamic-map Outside_dyn_map 20 set transform-set ESP-3DES-SHA
crypto map Outside_map 65535 ipsec-isakmp dynamic Outside_dyn_map
crypto map Outside_map interface Outside
isakmp identity address
isakmp enable Outside
isakmp policy 10 authentication pre-share
isakmp policy 10 encryption 3des
isakmp policy 10 hash sha
isakmp policy 10 group 2
isakmp policy 10 lifetime 86400
isakmp nat-traversal 20
telnet 10.10.10.0 255.255.255.0 inside
telnet timeout 5
ssh timeout 5
console timeout 0
tunnel-group try type ipsec-ra
tunnel-group try general-attributes
address-pool Dial-In
default-group-policy try
tunnel-group try ipsec-attributes
pre-shared-key welcome
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map global_policy
class inspection_default
inspect dns maximum-length 512
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
!
service-policy global_policy global
Cryptochecksum:xxxx
: end
