Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have already configured the switchport in trunk mode.Once I configured it as trunk, I am not able to add the following statementSwitch1#switchport trunk encapsulation dot1qIt always fails. I also tried the followingSwitch1#no switchport mode ...
Hi,I need to know what are the access-lists which are present in the ASA.Show access-list gives all the access-list names access-list entries.My acccess-list entries are long so It is hard to look for access-list which contains only two or one entrie...
Hi All,I am planning to upgrade my Cisco Distribution switches using Cisco 3750E switches using stackwise technologyCost is the major consideration for us. So we are thinking of buying Dell Switches for the Access Layer, will there be a problem in in...
Hi All,I have site to site vpn established with one of my client office. The client is changing their ISP now. I am wondering whether I need to delete the existing site to site vpn and recreate a new one with their new public IP address or do I just ...
Hi All,I have to create 8 different VLANS and have only 2 Interfaces left to play with.So I am planning to subinterface the existing Gi Interface and assign each sub interface to the VLANS.I am wondering how would I create access-list for each sub i...
Hi Nate,I am not planning to have an Core Layer.I am going to connect my Router and Firewall directly to Cisco Stack (My Distribution ) hence worried about HA between closetsI believe there are no other options availaible except for port channel betw...
Hello Nate,Thanks for the reply.So how do I interconnect two stackes in inter-closet. Do I need to run an fiber channel between the stacksAlso how can we achieve high availablity between these two stacksThanks,Chandru
Jorge,Thanks for your response. I will need to have Firewall ACLs between VLANs in my interanl Network. Please verify in that case, I should use only the Layer2 Switch functionality (Ofcouse, I have Layer 3, if we use SVI and enable routing then the ...
