I was wondering if anyone has successfully configured both TACACS and Radius on Cisco devices for aaa. We are looking to move to TACACS and have it reside on our ISE PSN's but I want to still keep radius as a backup as it will continue to reside on V...
I am trying to setup dual failover between a MPLS circuit and a broadband circuit back to my Data Center. Right now I have the MPLS connected to a Cisco router and the broadband connection connected to a ASA. All DC related traffic goes out the MPLS ...
Does anyone know what encryption is replacing key 7 for Radius? We have been using key 7 for radius and have had no issues but we just purchased a new 9200 catalyst switch and when you apply the key 7 option it states that "password 7 will soon be de...
I am wondering how to block routes that get redistributed from EIGRP into BGP. I have a 3850 advertising local networks via EIGRP to a 4331 router (MPLS) and these are then redistributed into BGP so they can be routed across my MPLS circuit. The issu...
I have an issue with load balancing between a single circuit at a remote site and 2 separate circuits, each going to it's own separate physical router in my DC. All circuits are managed by 1 single provider how ever the 2 circuits in the DC are throu...
Sorry all, for some reason I wasn't notified that any anyone responded. Attached is a diagram showing how things are setup and an example of the failover (track 1) that takes the interent traffic and sends it across the MPLS when the internet goes do...
Rick,
Maybe I didn't expalin well enough and I apologize for that. Here is the layout:
on my 3850 I have 7 networks defined (VLANs) and I am redistributing these networks into BGP that is running on my 4331 router (see snippet on original post ca...
