Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To fetch the show tech logs from the specified RSP path, you can use the following command:RP/0/RSP0/CPU0:HNI.MC01#admin show tech-support location 0/RSP0/CPU0This command will retrieve the show tech logs from the specified RSP path (0/RSP0/CPU0) and...
This issue might be related to the SFTP server or client you are using. To troubleshoot the problem, you can try the following steps:Ensure that you are using the latest version of the SFTP client software. Check for any available updates and apply t...
Hello! It sounds like you're having some issues with your network setup. Here are a few things you can check to troubleshoot the issue:Check the IP addresses of PC2 and PC3: Make sure that PC2 and PC3 have IP addresses that are on the same network as...
It sounds like there may be an issue with the network configuration for PC2 and PC3. Here are a few things you can try:Check the IP addresses for all devices: Make sure that PC2 and PC3 have valid IP addresses that are on the same network as PC0 and ...
The situation you have described can be challenging. While it is possible to configure queues in all of the hunt pilots, this may not be the most efficient solution and can consume excessive resources on the Cisco software/hardware. Additionally, thi...
